Page 27 of 116
©HALE PRODUCTS, INC. Our policy is one of continuous development. We therefore
reserve the right to amend specifications without notice or obligation.
PUMP CLEARANCE
• Pump service area is depicted within the zones illustrated below. DSD unit pictured, but
clearances for drive belt and anodes are common among all units.
• A pump clearance plate is installed to the pump guard to ensure proper clearance for major
pump service. This plate must remain on the pump.
• Suction manifold: Anode service areas are also required.
• DO NOT install any other components in this area that cannot be easily removed.
Figure 23: Service Zones Pictured (Dimensions are recommended minimums)
To Next Page
Loading...
