30 iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3
Configuring TRANSEC ACC Keys
6.2 Loading ACC Keys
If the current ACC Keys and pass phrase are not available, coordinate with the Network
Operator to obtain them over a secure link. The procedure for retrieving the current ACC Keys
from the hub is documented in the iDX iBuilder User Guide, available on the TAC Web site.
Sample ACC Keys are shown in Figure 20.
Figure 20. ACC Key Example
To Load the ACC Keys:
1. Open a terminal session to the Sa
tellite Router and log in to the root account. (See
“Connecting to the Console Port” on page17 for details.)
2. Enter the comman
d:
telnet localhost
3. At the Username prompt, log
in to the admin account.
4. At the command line prom
pt, enter the command:
csp enable
5. Enter the comman
d:
keyroll_mgr setACCKey
6. A prompt appears for each of the three segments (lines) of the encrypted key and the
pass phrase
. Respond to each prompt with the requested information. You can type Q to
quit at any time.
7. When asked to continue, enter:
Yes
A me
ssage appears stating that the Network Acquisition Key has been updated.
After loading the ACC Keys, continue to “Pointing the Antenna with iSite” on page31.
To Next Page
Loading...
