iDirect Satellite Router Installation and Commissioning Guide 41
iDX Release 3.3
8 Connecting with Web
iSite
This chapter describes the browser requirements for using Web iSite and how to determine
the IP address of an X1, X7 or e150 Satellite Router if it is unknown.
This chapter includes the following sections:
• “Web iSite” on page 41
• “IP Address” on page 41
• “Restoring Factory Defaults” on page 42
• “Cold Start: X1 Outdoor” on page 45
Note: If the internal temperature of an Evolution X1 Outdoor Satellite Router
is
below -25
o
C when power is first applied, it may take up to four minutes to
become operational. See “Cold Start: X1 Outdoor” on page 45 for details.
8.1 Web iSite
Web iSite is hosted by the X1, X7, and e150 Satellite Routers, each of which serve Web pages
to a LAN connection. With Web iSite, a standard Web browser is used to access the Satellite
Router to perform functions such as viewing status, loading software, pointing the antenna,
and performing the cross-pol isolation and compression point procedures.
Web iSite is compatible with the following Web browsers:
• Internet Explorer (Version 7 and later)
• Mozilla Firefox (Version 8 and later)
• Google Chrome (Version 16 and later)
8.2 IP Address
To connect using Web iSite, the Satellite Router IP address and admin password must be
known. The Satellite Routers are shipped with the following factory default settings:
• IP Address: 192.168.0.1
• Subnet Mask: 255.255.255.0
• DHCP Server: Enabled
• ad
min pa
ssword: iDirect
To Next Page
Loading...
