1 INTRODUCTION
1.2 Intended Use
The intended use of the product is defined by the uses within the defined limits from the technical
data. The permissible electrical parameters and the defined permissible ambient conditions must be
observed in particular. These are specified in more detail later in this manual.
The intended use for this product can be found in the following section 3.
1.3 Target Group and Qualification
The product and this documentation are intended for technically trained professionals such as:
• development engineers
• plant designers
• assemblers/service personnel
• application engineers
Installation, commissioning, as well as operation is only allowed by qualified personnel. These are
persons who meet all the following requirements.
• have appropriate training and experience in handling motors and their control.
• know and understand the contents of this technical manual.
• know the applicable regulations
1.4 Symbols Used
All notes in this document follow a consistent form and are structured according to the following
classes.
,
The WARNING notice alerts the reader to possible dangerous situations.
Disregarding a warning can possibly result in moderate injury to the user.
• Within a warning, this describes ways to avoid hazards.
ð
This note indicates possible incorrect operation of the product.
Failure to comply with this notice may possibly result in damage to this product
or other products.
1.5 Product Safety
The following EU directives were observed:
• RoHS-Directive (2011/65/EU, 2015/863/EU)
• EMV-Directive (2014/30/EU)
1.6 Regulations
In addition to this technical manual, operation, commissioning is subject to the applicable local reg-
ulations, such as:
• Accident prevention regulations
• Local regulations for occupational safety
©2022 igus® GmbH 5
To Next Page
Loading...