Immergas MAGIS COMBO V2 - Page 4

MAGIS COMBO V2
4
Range of "split" inverter reversible air/water hybrid heat
pumps, composed of an outdoor condensing unit and an in-
door unit (with hydronic exchange unit with chiller unit and
condensation unit); a single "pack" code identies the complete
system (indoor unit + outdoor condensing unit). ere are 3
instant versions (MAGIS COMBO 4 V2, MAGIS COMBO
6 V2 and MAGIS COMBO 9 V2) and 3 PLUS versions
(MAGIS COMBO 4 PLUS V2, MAGIS COMBO 6 PLUS V2
and MAGIS COMBO 9 PLUS V2), all with single-phase supply
voltage. e water circuit is fully protected against freezing be-
cause it can be installed inside the home (in this case there is no
need to add antifreeze); it is, therefore, also particularly suitable
for cold climate areas.
Make the refrigerant connections between the outdoor unit and
the indoor unit.
MAGIS COMBO V2 is ideal for conditioning rooms in central
heating mode (maximum ow temperature 80°C) in cooling
mode, and can produce DHW instantaneously with plate heat
exchanger, or coupled with a separate storage tank unit (PLUS
model).
anks to the thrust integration of generators (heat pump and
indoor condensation unit) there are advantages with regard to
both installation and reduction of overall dimensions, compared
to “D.I.Y.” solutions.
e logic of integrated intelligent activation in the system’s elec-
tronics is able to determine the most convenient source of energy
at that time (heat pump / condensation unit) and - therefore - to
chose the source to activate; allows simplifying the electrical
connections (it is not usually necessary to provide the System
Manager, which is still available as optional to manage special
systems, such as systems spread over more than three zones).
e MAGIS COMBO V2 indoor unit is approved for outdoor
use in partially protected environment with IPX4D protection
degree.
MAGIS COMBO V2 also meets the requirements of the ErP
Directive (2009/125/EC) and ELD (2010/30/EC); there are a
number of optional kits available, which allow it to be used in
dierent plant applications.
Compared to a single condensing boiler, the system allows a
considerable energy saving; also, it occupies little space: it is ideal
for new residential constructions (especially the PLUS version,
which also uses the heat pump for the production of DHW,
facilitating legal compliance), but also for the replacement of
obsolete boilers in systems in which to encourage the use of
renewable energy (in this case, the instant version is particularly
suitable for the purpose).
It is ideal for very high energy classes in new residential con-
structions.
BENEFITS AND INCENTIVES FOR REPLACEMENT
Compared to a condensing boiler it obtains greater savings in
operating costs and can also benet from the subsidies in force
and the new ermal Account 2.0, in addition to the possible
wall ue gas exhaust (ref. Legislative Decree 102/2014).