Inateck BCST-91 - Connection Management; Disconnecting from Base; Bluetooth SPP Mode Setup

Enter Setup
Exit and Save
16
3) How to Disconnect a base
If you have paired the scanner with two different bases, these two bases can both connect the
scanner. If you want to disconnect one of them, please follow the steps below: make sure the
scanner is connected with the base that should be disconnected, and then scan the barcodes
in turn "Enter Settings" - "Disconnect base" - "Save and Exit". The scanner will disconnect from
the base.
Disconnect base
Wireless Bluetooth Mode
Bluetooth SPP Mode
Bluetooth SPP mode is not the default mode. To enter this mode, please read the barcode
“Enter setup”, “Bluetooth SPP Mode” and “Exit with save”.
Bluetooth SPP Mode
When switched to Bluetooth SPP mode, the BCST-91 will enter into Bluetooth broadcasting
mode and the blue LED indicator flashes. Then you can search the Bluetooth of BCST-91 and
get it paired on your phone/computer. After successful pairing, you need to run serial
debugging tool on your computer, and select Open Bluetooth COM Port. You will then hear
three chord sounds (from high to low) to indicate the successful Bluetooth connection.
Note: There might be two Bluetooth COM ports on the list. If the connection fails, please try
the other COM port.