Inateck BCST-91 - Additional Code Recognition Control; Recognition Modes and Separation Character; Caps Lock Control

Enter Setup
Exit and Save
41
Mode of Recognition Only for Barcodes with Additional Code
The scanner can only recognize the barcodes with additional code if you set the mode as
"Recognition Only for Barcodes with Additional Code".
The scanner can recognize the barcodes without additional code if you set the mode as
"Recognition Not Only for Barcodes with Additional Code".
Recognition Only for Barcodes with
Additional Code
(*)Recognition Not Only for Barcodes with
Additional Code
Separation Character
You may decide whether to add a separation character "-" between the main code and
additional code. This function is applicable to the barcodes with additional code, e.g., ISBN
code, and ISSN code.
Add Separation Character
(*) Do not Add Separation Character
Caps Lock Control
When using the BCST-91 on a Windows system, the content of a barcode may change with
the status of the caps lock key. To avoid errors caused by such change, you may enable the
"Rid Barcode of Caps Lock Control".
(*) Caps Lock Control Barcode
Rid Barcode of Caps Lock Control
Read Code with Specific Initial Characters Only
Under this mode you may set 1-6 digits as initial characters, and the scanner will only