Inateck BCST-91 - Data Editing and Output Control; Prefix;Suffix Setting Steps; Deleting Output Characters

Enter Setup
Exit and Save
37
prefix and suffix. Please refer to the Appendix for the supported prefix/suffix characters.
Steps to set the prefix as "#" and the suffix as "D" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set Prefix" barcode.
3. Read the "#" barcode in Appendix I.
4. Read the "Set Suffix" barcode.
5. Read the "D" barcode in Appendix I.
6. Read the "Exit and Save" barcode.
Note: After you successfully set prefix and suffix, the BCST-91 will by default output scanning
result with prefix and suffix.
Set prefix
(*)Show prefix
(*)Show suffix
Set suffix
Hide prefix
Hide suffix
Delete Characters on Output Result
When outputting scanning result, the BCST-91 supports deleting 0 – 99 digit(s) front
characters and 0–99 digit(s) end characters from a barcode.
Steps to set deleting front 12-digit characters and end 4-digit characters are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the Number of Front Digit(s) to be Deleted" barcode.
3. Scan the "1 Digit" barcode.
4. Scan the "2 Digits" barcode.