Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-Operating-Instructions-jina54en1-09-(2404) 23 / 46
Control unit
The control unit settings can be reset to factory settings.
Control unit Functions > Data > Parameters > Reset >
Control unit settings
6.3.4 Recording data
The data is saved as a TXT file. Each TXT file contains the following information:
• Date created
• Software version
• Serial number
• Start time
• Time stamp (measurement indicates offset in seconds in relation to start time)
• File name
• Time stamp (offset in seconds in relation to start time)
• Leak rate (expressed in selected unit)
• Pressure p1 (expressed in selected unit)
• Device status
Switching on/off
Switching data recording on/off
• Off
• On
Control unit Functions > Data > Recorder > Settings >
Data recording
Record interval
Time interval between data recordings
• 100 ms, 200 ms, 500 ms, 1 s, 2 s, 5 s
Control unit Functions > Data > Recorder > Settings >
Record interval
Memory location
The data stored in the control unit can be saved to a USB stick. The memory in the
control unit is limited to the recording of a 24-hour measurement. Each time after one
hour has elapsed, the file is closed and recording continues in the next file.
• USB flash drive
• Control unit
Control unit Functions > Data > Recorder > Settings >
Storage location
Copy data
Copy data from the internal memory of the control unit to a connected USB stick.
Control unit Functions > Data > Recorder > Copy >
Copy files
Delete data
Delete data in the internal memory of the control unit