Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-Operating-Instructions-jina54en1-09-(2404) 17 / 46
16 - Value axis
Value axis of the leak rate Q(t).
17 - Device of measurement
Device of measurement of the value axis.
18 - Display equivalence leak rate
Correction factor for the test gas used.
6.2 Elements of the error and warning display
Displayed
message
with details
Detailed display
further active
errors or
warnings
(if present)
To the display
further active
errors or
warnings
(if present)
WARNING
Number: 500
Pressure sensor not connected
(Value = 4.23E-2)
Further errors or warnings
To confirm
all messages
Information to
cause or remedy
to the message shown
above
501
502
You will find an overview of possible errors and warnings in the operating instructions
of the LDS3000 (mass spectrometer module), chapter "Warning and error messages".
6.3 Settings and functions
Settings and functions of the control unit are explained in the following. You will find
the settings and functions of the mass spectrometer module LDS3000 you can set
using the control unit in the operating instructions of the mass spectrometer module.
6.3.1 Touch screen settings
The touch screen grays out the parameters if