Inficon CU1000

6 | Operation CU1000 INFICON
18 / 46 CU1000-Operating-Instructions-jina54en1-09-(2404)
• the user is not authorized to change the values, see also “Operator types and
authorizations [}21]“.
• an older version of the software run by mass spectrometer module LDS3000 does
not support this parameter.
Scaling of the
Q(t)axis
Linear or logarithmic
Lin.
Log.
Control unit Display > Q(t) axis > Linear or logarithmic
Number of decades with logarithmic view
1
2
3
4
Control unit Display > Q(t) axis > Decades
Autoscale
Disabled: You can change the display by pressing on the intersection of the
coordinate axes and then swiping your finger along the desired axis and releasing it,
or if you press on the end of the desired coordinate axis and swipe along in the
direction of the intersection of the axes and release.
On: The display is automatically adjusted depending on the leak rate.
Control unit Display > Q(t) axis > Auto scale
Scaling of the time
axis
Scaling of the time axis
15 s
30 s
60 s
120 s
240 s
480 s
960 s
Control unit Display > Time axis > Time axis scale
Display units
Device of pressure
mbar
Pa
atm
Torr
Control unit Display > Units (display) > Pressure unit
Measured value
display
Type of graphic display