Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-Operating-Instructions-jina54en1-09-(2404) 19 / 46
Diagram
Bar graph
Control unit Display > Measurement view > Measurement view mode
Numeric representation of the measurements
Off
On
Control unit Display > Measurement view > Show value
Display brightness
Display brightness
20 ... 100 %
Control unit Display > Brightness > Display brightness
Trigger display on the
touch screen
Selection of the trigger (leak rate threshold) displayed on the touch screen.
1
2
3
4
Control unit Settings > Trigger > Trigger sel.
Assigning favorite
buttons
The favorite buttons offer direct access to individual functions. They can be assigned
with access control "Supervisor" or higher by the user.
Favorite 1: Middle button (see the figure in “Measurement display elements [}14]“).
Favorite 2: Right button
Favorite 3: Button on the bottom right of the main menu.
Volume
Display settings
Start/Stop
Measurement view
(at AQ instead of : AQ, at instead of : )
CAL
Flow switching
Check CAL
At AQ additionally: AQ Wizard
Gas equivalent
- - - (= without function)
Control unit Settings > Favorites > Favorite 1 (2, 3)
Displaying warnings
on the touchscreen
The display of warnings on the touchscreen can be allowed or suppressed.
Off
On