2 | Safety INFICON
6 / 46 CU1000-Operating-Instructions-jina54en1-09-(2404)
2 Safety
2.1 Intended use
The device is intended for querying and configuring the data of the mass spectrometer
module LDS3000.
► Only install, operate and maintain the device indoors in accordance with these
instructions.
► Maintain the application limits (refer to Chapter 4.3).
2.2 Duties of the Operator
• Read, observe, and follow the information in this manual and in the work
instructions provided by the owner. This concerns in particular the safety and
warning instructions.
• Always observe the complete operating instructions for all work.
• If you have any questions about operation or maintenance that are not answered
in this operating instructions, contact INFICON service.
2.3 Owner requirements
Safety conscious
operation
Operate and install the device only in technically perfect working order and as
specified, in a safety-conscious and hazard-conscious manner and in compliance with
these instructions.
► Fulfill and ensure compliance with the following regulations:
- Intended use
Universally valid safety and accident prevention regulations
- International, national and local standards and guidelines
- Additional device-related provisions and regulations
► Use only original parts or parts approved by the manufacturer.
► Keep this manual available at the operating site.
Personnel
qualifications
► All work must be performed only by technically qualified specialists who have been
trained on the device.
► Allow personnel in training to work on the device only under the supervision of
technically qualified specialists.
► Make sure that the authorized personnel have read and understood these
instructions and all other applicable documents (refer to "Other associated
documents"), especially the information on safety, maintenance and repairs, before
starting work.
To Next Page
Loading...
Need help?
General
