INFICON Operation CU1000 | 6
CU1000-Operating-Instructions-jina54en1-09-(2404) 33 / 46
2 Connect the USB flash drive to the USB port on the device.
3 Select: "Functions > Data > Update > I/O module"
ð The display shows information on the current and the new software as well as
on the current boot loader.
4 Check the version information.
5 Select the "Start" button to start the update.
ð Do not switch off the device and do not remove the USB flash drive while the
software is being updated!
6 Follow the instructions on the touchscreen and wait until the update is
complete.
ð The following tips are shown after selecting the "Start" button on the
touchscreen:
• Connect and switch on the IO1000.
• Activate boot mode (switch DIP S2.3 on and off once).
• When the STATUS LED flashes green, press OK.
Fig.9: DIP switch on the I/O module
To Next Page
Loading...
