78 Equipment Settings
Calibration history
In this listing all calibrations that were conducted during the operation of the Protec
P3000 are collected. The
DATE and TIME when they were performed are stated,
followed by the type of calibration (internal / external) and the calibration factor.
Sniffer tip filter
The maintenance interval for the sniffer tip filter depends on the operating environ-
ment and may be set to values between 10 and 999 hours. If set to
the reminder
message for the sniffer tip filter will be disabled.
Default value: 100 hours
For details on how to perform the maintenance tasks see Chapter 7, Maintenance.
When confirming that the filter has been replaced (without changing the interval time)
press okay only and the counter will restart.
Fig. 59 Example of an Protec P3000 error list
Fig. 60 Example of a Protec P3000 Calibration history
To Next Page
Loading...
Need help?
General
