17
English
Installation
Powering On/O the Projector
Turn on the
projector rst and
then select the
signal sources.
Powering On the Projector
1. Securely connect the power cord and signal cable. When
connected, the On/Standby LED will turn Red.
2. Turn on the lamp by pressing “ ” button either on the top of
the projector or on the remote. The On/Standby LED will now
blink Blue.
The startup screen will display in approximately 10 seconds.
The rst time you use the projector, you will be asked to
select the preferred language.
3. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to “Options”.
Make sure that the “Source Lock” has been set to “O ”.
If you connect multiple sources at the same time, press the
“SOURCE” button on the Keypad or direct source keys on
the remote control to switch between inputs.
Power
To Next Page
Loading...
