23
English
User Controls
Keypad
Keypad & Remote Control
Using the Keypad
POWER
Refer to the “Power On/O the Projector” section on
pages 17-18.
RE-SYNC
Automatically synchronize the projector to the input
source.
ENTER
Con rm your item selection.
SOURCE
Press “SOURCE” to select an input signal.
Menu
Press “Menu” to launch the on-screen display
(OSD) menu. To exit OSD, Press “Menu” again.
Help
Help Menu (only available when OSD menu is not
shown).
Four Directional
Select Keys
Use to select items or make adjust-
ments to your selection.
Keystone
/
Use to adjust image distortion caused
by tilting the projector. (±40 degrees)
Lamp LED Indicate the projector’s lamp status.
Temp LED
Indicate the projector’s temperature status.
On/Standby
LED
Indicate the projector’s status.
To Next Page
Loading...
