InFocus X16 Reference Guide

Operation 21
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes
an option for setting up password security. The password can be set through the
On-Screen Display (OSD) menu. For details of the OSD menu operation, please
refer to "Using the menus" on page 20.
You will be inconvenienced if you activate the password functionality and subsequently forget
the password. Print this reference guide (if necessary) and write the password you used in
this guide, and keep it in a safe place for later use.
Setting a password
Once a password has been set, the projector cannot be used unless the correct password is
entered every time the projector is started.
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security
Settings menu. Press MODE/ENTER. The Security Settings page displays.
2. Highlight Power on lock and select On by pressing / .
3. As pictured to the right, the four arrow keys
( , , , ) respectively represent 4
digits (1, 2, 3, 4). According to the password
you desire to set, press the arrow keys to
enter six digits for the password.
4. Confirm the new password by re-entering
the new password.
Once the password is set, the OSD menu
returns to the Security Settings page.
The digits being input will display as asterisks on-
screen. Write your selected password down here in this reference guide in advance or right
after the password is entered so that it is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this reference guide in a safe place.
5. To leave the OSD menu, press MENU/EXIT.
If you forget the password
If the password function is activated, you will be
asked to enter the six-digit password every time
you turn on the projector. If you enter the wrong
password, the password error message as
pictured to the right displays lasting for three
seconds, and the message 'INPUT PASSWORD'
follows. You can retry by entering another six-digit
password, or if you did not record the password in this reference guide, and you
absolutely do not remember it, you can use the password recall procedure. See
"Entering the password recall procedure" on page 22 for details.
If you enter an incorrect password 5 times in succession, the projector will
automatically shut down in a short time.
INPUT NEW PASSWORD
BackMENU
Password Error
Please try again.

InFocus X16 Specifications

Display

native resolution	800 x 600
display technology	0.55” LVDS DLP DMD
brightness	2400 lm

Connectivity

input sources	VGA (HD15), S-video, Composite Video, Audio (3.5mm), RS232
output sources	VGA (HD15)
control	PC control through RS232

Video Compatibility

computer compatibility	VGA(640x480), SVGA(800x600), XGA(1024x768), SXGA(1280x1024), SXGA+(1400x1050)
video compatibility	NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, SECAM, SDTV(480i/576i), EDTV(480p/756p), HDTV(720p1080i)
aspect ratio	4:3/16:9

Projection

minimum projection distance	1.5 ~ 6m
lens offset	120%
image size	0.75m ~ 6.5m (27” ~ 252")

Power and Consumption

power consumption	285W (typical) / 5W in standby
power supply	100~240Vac, 50/60Hz
lamp	185W / 4000 hours (Eco mode)

Operating Environment

operating temperature	5 – 35°C
audible noise	29dB
brightness uniformity	80%

Weight and Dimensions

product dimensions	225 x 113 x 264mm
product weight	5.3 lbs (2.4 kg)
product color	Black