Ingenico iWL200 Series - First Config Menu Screen; Second Config Menu Screen

Terminal User Guide Troubleshooting
81
First Supervisor Menu Screen
HANDSET ID
F1
Allows the HANDSET ID value displayed on the idle
screen and printed on each ticket to be set. The
default value is 01.
PASSWORD
F2
Allows the various passwords in the terminal to be
reset or changed. Enters the PASSWORD menu - see
next section.
CONFIG
F3
Allows the access to various extended configuration
options. Enters the CONFIG menu - see next section.
LOGON
F4
Allows the terminal to perform a test with some, or
all, of the acquirers loaded on the terminal. Do not
use this feature unless instructed to do so by the
terminal Helpdesk.
Second Supervisor Menu Screen (press menu once)
SHORT CUT
F1
Allows access to advanced configuration options.
Enters the SHORT CUT menu - see next section.
TIPS
F2
Allows the Gratuity/Tip mode to be switched on and
off. Setting TIPS to ON, sets OP MODE to LATE.
OP MODE
F3
Allows the setting of when the terminal will contact
the acquirer for authorisation during the transaction.
Gratuity/Tip mode is only available in LATE mode.
Setting OP MODE to EARLY, sets TIPS to OFF.
CALL TMS
F4
Immediately sets off a configuration data call to the
Terminal Management System (TMS). Do not use
this feature unless instructed to do so by the
terminal Helpdesk.