54 Commands over-the-phone
Anti-intrusion control panels
8-3-5
Listen-in
Type-in the PIN of an authorized user code followed by “#” on the telephone keypad, then
press the key (from “0” to “9”) which the installer has programmed to activate “Listen-in”
(shortcut n.10).
The control panel will open a listen-in channel between the users telephone and the first
voice-capable keypad with at least one partition on common with the entered code. During
the listen-in phase, the user can open a voice-communication channel with another keypad by
pressing the number key which corresponds to the address of the selected keypad. Also in this
case, the selected keypad must have at least one partition in common with the entered code.
Press “*” to end the listen-in session and step back to the voice-announced Shortcut menu.
8-3-6
Partition status enquiry
Type-in the PIN of an authorized user code followed by “#” on the telephone keypad, then
press the key (from “0” to “9”) which the installer has programmed to activate “Arming
status” (shortcut n.17).
The control panel will announce (in order) the descriptions of the partitions the entered PIN is
assigned to and their current armed/disarmed status.
Press “*” to step back to the main menu in order to listen to the voice messages relative to
the shortcuts available for the authenticated code.
To Next Page
Loading...
