INIM Electronics Prime Series

User’s manual
Commands over-the-phone 53
where:
• <xxxxxx> stands for the PIN of a control panel user
• a blank space must be keyed in after PIN entry
• <SMS Text> which is the command identifier - this parameter must be provided by your
installer.
If duly configured (by the installer), the user will receive feedback (SMS text message or ring)
from the Nexus relating to successfully implemented commands.
SMS TEXT AT
DEFAULT
By default, commands are predefined and can be modified by the installer:
•“CONNECT” for a request for remote assistance via SMS text (future use).
•“CREDIT” - for balance enquiries relating to the SIM card of the Nexus, the user will
receive an SMS text indicating the remaining credit.
•“STATUS” - for status enquiries relating to the Nexus, the user will receive an SMS text
indicating the:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• device tamper status
•• BUS status
•• Balance (remaining credit)
•• scenario active (if present)
•“EXC” (or “ESC”), to inhibit the control panel zones
•“INC”, to activate the control panel zones
For the last two commands, the message text must be:
<xxxxxx> EXC <zone description>
where:
- <xxxxxx> is the PIN of a control-panel user coded, followed by a blank space
- “EXC” (or “ESC” or “INC”) is the command to be implemented on the zone, followed
by a space
- <zone description> is the name zone to be inhibited or activated
8-3
Operations via telephone
8-3-1
Alarm management
The operations that can be performed via the keypad in the event of alarm or tamper are:
• Stop alarms
• Clear call queue
• Delete memory
Type-in the PIN of an authorized user followed by “#” on the telephone keypad, then press
the key (from “0” to “9”) which the installer has programmed to “Stop alarms” (Shortcut n.2),
“Clear call queue” (Shortcut n.3), “Delete memory” (macro n.4).
8-3-2
Arming commands and scenarios
Type in an authorized code PIN followed by “#”. Press the number key (from “0” to “9”)
associated with the “Arm/Disarm” shortcut (shortcut n.1) in order to apply the pre-set
scenario.
8-3-3
Activation of outputs
Type-in the PIN of an authorized user code followed by “#” on the telephone keypad, then
press the key (from “0” to “9”) which the installer has programmed to activate “Activate
output” (Shortcut n.5) or “Deactivate output” (Shortcut n.6).
8-3-4
Overtime request
Type-in the PIN of an authorized user code followed by “#” on the telephone keypad, then
press the key (from “0” to “9”) which the installer has programmed to activate “Overtime”
(shortcut n.7).