28 Keypads
Anti-intrusion control panels
6-1
Keypad displays
6-1-1
LCD keypad
The screens of LCD keypads (96 x 32 pixel) are backlit, it is possible to adjust the screen
brightness and contrast via the respective options on the user menu (refer to paragraph 6-6-
8 Keypad settings).
The following table describes the messages which are shown on the keypad display, in
accordance with the actual status of the control panel:
• Stand-by - indicates the control panel is functioning normally and there are no alarm,
tamper of fault events present on the system.
• Alarm or Zone tamper - indicates that the control panel has detected trouble on a zone,
such as zone violation (intrusion) or detection of a lost device
• Maintenance - indicates that the control panel is in maintenance mode for repair or
programming purposes
18:23 01/01/2019
DASIDASI--
Table 6-2: Display visualization
Line
Control panel status
Stand-by Alarm or tamper Maintenance
1
The first line of the display shows the date and time.
If at least one of the keypad partitions
has saved an alarm or tamper event to
the memory, the first line of the screen
will flash the descriptions of the zones
concerned every 3 seconds.
Note
Open zones are signalled by
blinking on the red LED .
If the control panel is in Service
mode, a string will be shown indicat-
ing the address of the keypad in use
(in the figure, the keypad is at
address 3).
If the keypad is equipped with a thermostat, the date and
room temperature will alternate on the screen every 3 sec-
onds.
If you are using a keypad with an
integrated proximity reader, the
string will also show the address of its
reader (in the figure, the reader is at
address 5).
If the “View open zones” control-panel option is enabled,
the descriptions of zones that are not in standby status
when the keypad partitions disarm will be shown in
sequential order approximately every 3 seconds.
Any auto-bypassable zones will be shown in white on black
background.
If the control panel is in Service mode and at least one of the keypad partitions
has saved an alarm or tamper event to the memory, the above-described
strings will alternate on the display.
2
left
The left side of the second line shows the characters that
indicate the current status of the partitions the keypad is
assigned to:
•
= partition disarmed
•
= partition armed in Away mode
•
= partition armed in Stay mode
•
= partition armed in Instant mode
•
= partition does not belong to the keypad
In the case of the Prime060S and Prime060L, the display
will show 10 characters indicating the status of partitions 1
to 10.
In the case of the Prime120L and Prime240L, the display
will show 10 characters, which alternate at 3 second inter-
vals, indicating the status of partitions 1 to 10 and then 5
characters indicating the status of partitions 11 to 15.
In the event of a partition alarm
or tamper memory, the red LED
on the keypad and the charac-
ters corresponding to the parti-
tions concerned will blink.
The line is the same as when the con-
trol panel is in standby condition.
If the “Show scenario” control panel parameter is active, the left side of the second line on the screen will display the current scenario.
2
right
On the second line, on the right side, you can see several icons which provide system information.
For a detailed description of these icons refer to Table 6-4: Information icons.
3
4
Lines three and four on the display are occupied by the icons which correspond to the shortcuts assigned to function keys , ..., .
If no shortcuts are programmed on the keypad function keys, the respective spaces on the display will remain empty.
To Next Page
Loading...
