50 Readers and Keys
Anti-intrusion control panels
7-2-1
Wireless keys (remote-control keys)
The wireless keys have 4 buttons which can each be programmed with a shortcut. The
graphic-choice feature allows you to identify the buttons by numbers or icons.
The wireless keys also have 4 button-associated LEDs and a confirmation LED. Thanks to two-
way communication (transceiver), the LEDs and buzzer on the remote-control keys provide
users with feedback signals that notify them of the successful outcome or failure of the
requested operation:
Note
If an operation is successful, but the corresponding LED fails to light, it is an indication that the battery
is low.
The battery must be replaced before it runs out completely.
7-3
Reader and key operations
7-3-1
Alarm management
The operations that users can perform via proximity readers or keys, in relation to alarm and/
or tamper events, depend on the programming of the associated shortcuts.
Via Reader
Hold a valid key in the vicinity of the reader until the reader LEDs or display indicates “Stop
alarms” (shortcut n.2), “Clear call queue” (shortcut n.3), “Delete call memory” (shortcut n.4).
Via Wireless
key
Push the respective button on the wireless key and verify the outcome of the requested
operation, as described in paragraph 7-2-1 Wireless keys (remote-control keys).
7-3-2
Arming commands and scenarios
Via a reader or key it is possible to activate the programmed scenarios for the associated
shortcuts:
Via Reader
Hold a valid key in the vicinity of the reader and remove it when “Arm/Disarm” (shortcut n.1)
is indicated on the LEDs (the system will apply the preset scenario).
Via Wireless
key
Push the respective button on the wireless key and verify the outcome of the requested
operation, as described in paragraph 7-2-1 Wireless keys (remote-control keys).
Table 7-3: Feedback signals provided by wireless keys
Button Icon LED 1 LED 2 LED 3 LED 4 Buzzer signal Operation
1 flash beep Activates shortcut 1
1 flash beep Activates shortcut 2
1 flash beep Activates shortcut 3
1 flash beep Activates shortcut 4
+
+
1 flash 1 flash beep Block/Unblock remote-control device
Any
4 flashes 4 flashes Remote-control device blocked
Table 7-4: Control panel signals over wireless keyfob
Feedback from panel Confirmation LED - green Confirmation LED - red Buzzer signal
Command not received
1 flash
Operation not done
4 flashes bop
Operation done
3 flashes long beep
To Next Page
Loading...
