User’s manual
Glossary 63
Appendix
A
Glossary
Detection of non-authorized entry into the protected building. More specifically, activation of
a detector.
ALARM
In the event of:
•Zone Alarm
•terminal tamper
• open panel or dislodged panel
• peripheral tamper
• peripheral loss
•false key
The red LEDs on the system keypads and readers go On each time one of the previously-
mentioned events occur. This visual warning signal is held even after the event ends (alarm
memory), in order to warn you that an event occurred during your absence. This visual
warning signal will be held until you clear the event memory (refer to Delete Memory).
ALARM OR TAMPER
MEMORY
This is a private service that monitors premises protected by intrusion control systems
equipped with digital communicators or voice dialers.
Alarm Receiving Centres receive alarm reports from monitored systems and take all the
necessary actions to protect the occupants of the protected premises.
ALARM RECEIVING
CENTRE (ARC)
The “Answerphone” function, if enabled by the user, allows the control panel to answer
incoming calls after a pre-set number of rings. The control panel will pick-up and play the
recorded answer message.
During the call, the recipient can type-in a valid PIN (enabled for over-the-phone control)
and access the authorized functions.
ANSWERPHONE
User operations on one or more partitions. These generally indicate also the status of the
partitions. Under normal circumstances, the zones of armed partitions can generate alarms.
Under normal circumstances, the zones of disarmed partitions cannot generate alarms. The
system generates tamper alarms even when partitions are disarmed.
ARM/DISARM
You can enable/disable the Auto-arm function on each separate partition.
If the auto-arm option is enabled on a timer-controlled partition, the partition will arm/
disarm in accordance with the ON/OFF settings of the timer.
AUTO-ARM
This is the secondary power source of the system. If primary (230 Vac) power failure occurs,
the battery will take over.
Prime control panels use 12V sealed lead batteries. The battery housing determines the
maximum size of the battery and therefore, its power-storage capacity. Prime control panels
can be equipped with lead batteries @12V 7, 9 or 17Ah. The control panel monitors the
battery continuously and keeps it is under constant charge (from Mains).
BACKUP BATTERY
A bypassed (disabled) zone cannot generate alarms. Each zone can be bypassed/
unbypassed manually by the system users, or automatically by the control panel. Automatic
bypass operations can take place only when the zone is configured as “Auto-bypassable” and
the conditions that regulate auto-bypass operations are in effect (refer to Zone Attributes –
Auto-bypassable).
BYPASS - ZONE
DEACTIVATION
A list of outgoing event-associated calls the control panel must send to programmed contact
numbers.
Enabled users can clear the call queue manually.
CALL QUEUE
The Cloud is a web service that provides data storage space (“cloud storage”) that, by
means of any Internet connection, is accessible at any time and from any place. The data
are then shared over the network, along with the resources to process them (“cloud
computing”) with all users who have a valid access.
The Cloud provider guarantees therefore that the user has both the resources for the
processing and editing of data, and data synchronization that can be accessed and modified
by multiple users without the risk of being lost.
CLOUD
These are 4, 5 or 6 digit PINs which allow the building occupants (users) to access the
system.
Each code can be programmed to control specific functions only, and to operate the system
to suit the requirements of the Main user.
Code types
• Installer code: used by the installer company technician
• User code: assigned to the building occupants
CODE
To Next Page
Loading...
