– Oxidizing agents (such as nitrous oxide [N2O] atmospheres).
– Endogenous gases.
The optical or RF energy and heating associated with the System can
provide an ignition source. Observe fire precautions at all times. When
using Optimas in the same room with any of these substances or gases,
prevent their accumulation or pooling within the area where Optimas
procedures are performed.
The operation of the Optimas may adversely influence the operation of
other electronic EQUIPMENT.
To avoid the RISK of electric shock, this equipment must only be connected
to a SUPPLY MAINS with protective earth.
2.11 Device Labels
As required by national and international regulatory agencies, appropriate warning
and information labels have been attached in specific locations on the instrument as
identified below.
The following device labels are located on the Optimas device console and the
handpiece:
Figure 2-1: System Certification and Identification Label
To Next Page
Loading...
