InMode Optimas - Fractora Treatment Parameters

Optimas System Operator Manual
Section 9: Fractora Treatment Information
56 of 87
▪ Establish and confirm treatment parameters: if the desired end-point of
erythema and edema – in a tip-shaped pattern – has not been achieved within
10-15 minutes, increase the RF energy. If the response is excessive, decrease the
parameters.
▪ Low energy levels of 10-25 may be tolerated after topical anesthesia application.
Energy levels of 25-40 may require nerve block or tumescent and high energy
levels of 40-62 may call for tumescent or IV sedation.
9.8 Treatment Recommendations
1. Apply the necessary means of anesthesia. If topical, make sure that it is
cleaned off the face before treatment and the skin is dried with alcohol 70%.
2. Ensure that skin is clean and dried with alcohol 70%.
3. Take an alcohol cleaned and dry tip and connect it to the Handpiece in the
groove.
4. Connect Handpiece to the System.
5. Follow Device Start-Up Procedure from System Operation section.
6. Refer to the most current QRG (Quick Reference Guide)
7. Set treatment parameters. Typical treatment parameters are shown in the
table below:
Clinical
Indications
Tip
Treatment
Area
RF
Energy
Level
No.
Sessions
Weeks
between
Sessions
Down
Time
Days
Superficial
- texture,
tone, very
fine lines
60
Soft tissue
10-25
3-5
1-4
0-1
Bony area
5-20
Moderate -
texture,
tone, fine
lines
60
Soft tissue
25-30
2-3
4-5
2-3
Bony area
20-30
Deep -
texture,
tone, fine
lines, fine
vessels,
wrinkles,
acne scars
60
Soft tissue
30
1-2
5-6
7-10
Bony area
25-30