InMode Optimas - Section 12: Troubleshooting Guide; System Fault Diagnosis

Optimas System Operator Manual
Section 12: Troubleshooting
76 of 87
Section 12: Troubleshooting
The Optimas System provides monitoring of all critical parameters to ensure safety of
patient and user. If any of the following faults are detected by the System
automatically goes to STAND BY mode.
12.1 Description of Faults with All Handpieces
Problem
Description and Checks
System did not turn on
▪ Check power cord connection.
▪ Check that main switch on rear panel is on.
▪ Check that On/Off switch on front panel is on.
▪ Check Emergency button not pressed.
▪ Check fuses on back panel of the System.
▪ Call Technical Service if problem persists.
System shuts down by
itself
▪ Check power cord connection.
▪ Check fuses on back panel of the System.
▪ Check Emergency button not pressed.
▪ Call Technical Service if problem persists.
Checksum
▪ The software was not loaded properly from
software plug.
▪ Check the plug connection and reboot the
System.
▪ Call Technical Service if the problem persists.
Fault H8002 - Handpiece is
not connected
▪ Check the connection of the Handpiece.
▪ Replace the Handpiece.
▪ Call Technical Service if the problem persists.
Fault H8005, H800F, H8010
– System Memory Fault
Call Technical Service if the problem persists.
Fault H8601 – Distributor
Card Connection Fault
Call Technical Service if the problem persists.
Fault H8609 – Water
Temperature Fault
Call Technical Service if the problem persists.