Figure 10-1: Recommended Forma Facial and Neck Treatment Zones
12. Apply 2-4mm clear ultrasound gel (not oil) to the treated zone and to adjacent
zone that can serve as a warm gel reservoir for replenishing gel in the
treatment zone with minimal delay.
Prior to using water-based gel, ensure that the container of ultrasound gel
has not passed the expiration date.
13. RF is continuous in Repeat mode and stops every 30sec in Single mode. Always
work in Repeat mode.
14. Assume full contact of Handpiece with the skin with a slight pressure.
15. Use your free hand to flatten and stretch treatment area if needed for
complete contact and smooth movement.
16. Press the Footswitch and initiate the RF energy.
17. Move the Handpiece in circular movements or back and forth with gentle
pressure over the full treated zone to reach uniform skin heating. Movement
should be constant and its amplitude should be at least double of Handpiece
spot size to avoid hot spots.
18. Continue to treat the area in this fashion. Always start with a low setting level
to check the patient’s tolerance to the treatment parameters and increase the
settings gradually.
19. Apply multiple passes to maintain the desired temperature during ~5-7min on
face and neck. If cut-off temperature is <41°C, maintain the temperature for
additional 1-3min per zone.
To Next Page
Loading...
