Optimas System Operator Manual
Section 13: System Specifications
▪ The System should not be used adjacent to or stacked with other equipment. If
adjacent or stacked use is necessary, the System should be observed to verify
normal operation in the configuration in which it will be used.
Guidance and manufacturer’s declaration – electromagnetic emissions
The Optimas System is intended for use in the electromagnetic environment specified below. The
customer or the user of the Optimas should assure that it is used in such an environment.
Electromagnetic environment – guidance
The System uses RF energy only for its
internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
The System is suitable for use in all
establishments other than domestic and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
To Next Page
Loading...
