Inovance IS 300 Series - Page 83

Appendix IS300 Series Servo Drive User Manual
- 82 -
Function
Code
Name Setting Range Min. Unit Default Property
F4-49
AI2 sampling
voltage 2
-9.999–9.999 V 0.001 V 8.000 V ☆
F4-50
AI2 corrected
voltage 2
-9.999–9.999 V 0.001 V 8.000 V ☆
F4-51
AI3 sampling
voltage 1
-9.999–9.999 V 0.001 V 2.000 V ☆
F4-52
AI3 corrected
voltage 1
-9.999–9.999 V 0.001 V 2.000 V ☆
F4-53
AI3 sampling
voltage 2
-9.999–9.999 V 0.001 V 8.000 V ☆
F4-54
AI3 corrected
voltage 2
-9.999–9.999 V 0.001 V 8.000 V ☆
F4-55 to
F4-58
Reserved - - ☆
Group F5: Output Terminals
F5-00 Reserved Reserved Reserved Reserved ☆
F5-01
Control board relay
(T/A1-T/B1-T/C1)
output selection
0: No output
1: Servo drive running
2: Fault output
3: Frequency-level
detection FDT output
4: Frequency reaching
5: Running at zero speed
6: Motor overload warning
7: Servo drive overload
warning
8-11: Reserved
12: Running time reaching
13: Frequency restricted
14: Torque restricted
15: Ready to RUN
16: AI1>AI2
17: Frequency upper limit
reaching
18: Frequency lower limit
reaching
19: Under-voltage status
output
20: Communication setting
21-22: Reserved
23: Double-discharge
plunger pump sloping
switchover (NO)
24: Output NC in pressure
control
25: Slave pump alarms
1 2 ☆
F5-02
Control board relay
(T/A2-T/C2) output
selection
1 1 ☆
F5-03
Control board relay
(T/A3-T/C3) output
selection
1 0 ☆