Inovance MD500T75G - Page 47

MD500 User Manual 3. Electrical Installation
- 47 -
Ƶ
DC Bus Terminals
ƕ The DC bus terminals, labeled (+) and (–), are signal terminals that carry a residual voltage for a period after the AC drive
has been switched off.
ƕ To avoid the risk of electric shock, wait for at least 10 minutes after the CHARGE indicator goes off before you touch the
equipment.
ƕ 7RDYRLGWKHULVNRIHTXLSPHQWGDPDJHRUÀUHZKHQ\RXVHOHFWDQH[WHUQDOEUDNLQJXQLWIRUXVHZLWKDQ$&GULYHRIN:
and above, DO NOT reverse the poles (+) and (–).
ƕ Do not use a cable length of more than 10 m to connect the DC bus terminals to the external MDBUN braking unit. Use
twisted pair wires or close pair wires for this connection.
ƕ 7RDYRLGWKHULVNRIHTXLSPHQWGDPDJHRUÀUHGRQRWFRQQHFWWKHUHJHQUHVLVWRUGLUHFWO\WRWKH'&EXV7KH'&EXVLVD
signal connection only.
Ƶ
Regen Resistor
ƕ 7KHUHJHQUHVLVWRUWHUPLQDOVDQG3%DUHIRUXVHRQO\ZLWK0'$&GULYHXQLWVXSWRN:WKDWDUHÀWWHGZLWKDQ
internal braking unit.
ƕ To avoid the risk of equipment damage, do not use a cable length of more than 5 m to connect an external regen resistor.
ƕ To avoid the risk of ignition due to overheating of the regen resistor, do not place anything combustible around the regen
resistor.
ƕ 6HW)%UDNLQJXVHUDWLRDQG)%UDNLQJXQLWDFWLRQLQLWLDOYROWDJHSURSHUO\DFFRUGLQJWRWKHDFWXDOORDGDIWHU
FRQQHFWLQJUHJHQUHVLVWRUWR0'$&GULYHXQLWVXSWRN:WKDWDUHÀWWHGZLWKDQLQWHUQDOEUDNLQJXQLW
Ƶ
AC Drive Output
Cable clamp of
bare copper shield
Main circuit cables
Cable bracket
(optional)
Stick insulating tape around
the bare copper shield
above the cable clamp
Shield grounded
efesotomasyon.com