Mechanical Installation (T13 Models)
‑115‑
Figure 6‑1 Ground requirements
6.4 Installing Expansion Screws
To install the cabinet on a cement floor, embed expansion nuts in advance in the
floor at positions corresponding to the fixing holes of the cabinet for fixing the
cabinet.
The following figure shows the steps of installing expansion screws, where ❶
indicates an expansion screw, ❷ indicates the cabinet, and ❸ indicates an M12 bolt.
1. Drill a hole for the expansion screw. The hole diameter shall be slightly smaller than
the maximum outer diameter of the screw, and the hole depth shall be greater than
the expansion screw length. The expansion screw must be vertical to the ground, as
shown by "Step 1" in the following figure.
2. The expansion screw consists of a bolt spring enclosure and a screw part. Use a
hammer to knock the expansion screw into the hole and ensure that the screw
head is below the ground surface, as shown by "Step 2" in the following figure.
To Next Page
Loading...
