Unpacking Inspection
‑73‑
No. Name
6 Expanded polyethylene foam
7 Anti-inclination label
8 Side panel
3.4 Handling and Hoisting After Unpacking
T1 to T6 models are small and light and therefore can be handled manually. T7 to T13
models, however, must be transported with an appropriate lifting tool.
AC Drive Weight Personnel Required for Handling
< 15 kg
1
≥ 15 kg 2, with proper lifting device
Precautions for handling and hoisting:
● Handle the equipment in accordance with local laws and regulations.
● Avoid handling the AC drive by directly holding its upper cover or enclosure.
Before handling, check that all screws have been tightened. Failure to comply may
result in AC drive fall‑off, causing personal injury.
● For T10 to T12 models, when fastening the AC drive, ensure that the four mounting
holes on the back of the AC drive are securely connected to the fixing beam.
● Straighten the flat‑lying equipment before further handling.
● Ensure that the load capacity of the crane for transportation is larger than the
weight of the equipment.
● Ensure that the upper cover, terminals, and other components of the AC drive are
secured firmly with screws before vertical lifting. Failure to comply can lead to
personal injury.
● When lifting the AC drive with the lifting rope, avoid subjecting the AC drive to
excessive vibration or impact. Failure to comply can lead to personal injury.
● When lifting the AC drive with the lifting rope, do not turn the AC drive over or
leave it suspended for long time. Failure to comply can lead to personal injury.
T1 to T9 models
To lift T1 to T9 models, do as follows:
1. Hook the lifting rope to the two auxiliary lifting lugs at the top of the drive.
It is recommended that the lifting angle be greater than 45 degrees and the height
fluctuation be no greater than 0.3 m.
To Next Page
Loading...
