Inovance MD520 Series - MRP Function and Fault Diagnosis

Mechanical Installation (T1 to T9 Models)
‑97‑
b. Hold the cover with both hands and lift it up in the direction indicated by the
arrow.
4.6.2 Installing the Cover
The cover of the AC drive must be removed before wiring the main circuit and control
circuit. After wiring is done, re‑install the cover.
1. Install the cover for T1 to T6 models.
a. Hold the cover with both hands and insert the upper edge snap‑fit joint of the
cover into the hole on the drive.