Preparations for Installation
‑29‑
Figure 1‑17 Installation direction (T10 to T12 models)
1.3 Installation Tools
1.3.1 Mechanical Installation Tools
T1 to T9 models
"
Table 1–7 Tools for mechanical installation
"
on page 29
lists the tools for mechanical
installation.
Table 1–7 Tools for mechanical installation
Tool
Description
Electric drill with appropriate drilling bits It is used to drill mounting holes on the
mounting surface.
Nut wrench or socket wrench It is used to tighten or loosen screws.
The following specifications are required:
#13, #16, and #18.
Phillips screwdriver and straight
screwdriver (2.5 mm to 6 mm)
It is used to tighten or loosen screws.
Torque wrench It is used to tighten or loosen screws.
Crowbar It is used to pry off the upper cover or cover
to facilitate installation.
Crane
It is used to lift the drive.
Tape measure
It is used to measure the installation
dimensions of the device.
Gloves They are used to prevent static electricity
during mechanical installation.
Bottom mounting bracket (standard) It is used to fix the AC drive in the cabinet.
To Next Page
Loading...
