Preparations for Installation
‑51‑
Note
● The bottom mounting brackets shown in the preceding figures are applicable to
PS standard cabinets, sized either Width 800 mm x Depth 600 mm or Width 800
mm x Depth 800 mm. Dimensions in parentheses are applicable to PS standard
cabinets sized Width 800 mm x Depth 800 mm.
● The bottom mounting brackets that come standard with T10 to T12 models are
only applicable to PS standard cabinets sized Width 800 mm x Depth 600 mm.
1.4.5 Guide Rail
For details of the guide rail, see
Operation Instructions for MD500‑AZJ‑A3T10 Guide
Rail
.
1.4.6 Installing the U/V/W Copper Busbar
All MD520 models excluding those with the base (‑L) are delivered with U/V/W output
side copper busbars. To install the U/V/W output copper busbars, follow the steps
below:
1. Use the screwdriver or cutting pliers to remove the three knockouts.
2. Use the four plastic snap‑fit joints in the packing box to fasten the insulating paper
to the chassis through the four holes on the paper.
To Next Page
Loading...
