Preparations for Installation
‑31‑
T13 models
See mechanical installation tools in "
Table 1–10 Tools for mechanical installation
"
on
page 31
.
Table 1–10 Tools for mechanical installation
Tool
Description
Wrench or socket wrench (18 mm) It is used to tighten or loosen screws.
Phillips screwdriver and straight
screwdriver (2.5 mm to 6 mm)
It is used to tighten or loosen screws.
Torque wrench (torque above 100 N•m)
It is used to tighten or loosen screws.
Electric drill with an appropriate drilling bit It is used to drill holes on the floor or steel
plates for fastening the cabinet.
Crowbar It is used to pry off the upper cover or cover
to facilitate installation.
Crane
It is used to lift the drive.
Tape measure
It is used to measure the installation
dimensions of the device.
Gloves They are used to prevent static electricity
during mechanical installation.
Select the screw with correct specifications; otherwise, improper installation may occur.
1.3.2 Tools for Wiring
When wiring the main circuit terminal, select an appropriate installation tool based
on the terminal size. "
Table 1–11 Tools for wiring the main circuit terminal
"
on page
31
lists the tools for wiring the main circuit terminal.
Table 1–11 Tools for wiring the main circuit terminal
AC Drive Model Recommended Fastener Tool
T1 to T2 M4 SEMS screw
Phillips screwdriver (#3 slot)
T3 to T4 M5 SEMS screw
Phillips screwdriver (#3 slot)
T5 to T6 M6 SEMS screw
Phillips screwdriver (#3 slot)
T7
M8 nut, spring washer, and
flat washer
Socket wrench (#13 socket)
To Next Page
Loading...
