Preparations for Installation
‑30‑
Tool
Description
Guide rails (optional) They are connected to the bottom
mounting bracket, enabling you to gently
push the AC drive into the cabinet along the
guide rails.
Screw
It is used to fix the equipment to the
mounting surface.
"
Table 1–8 Specifications and quantity of screws
"
on page 30
lists the specifications
and quantity of screws required for mechanical installation.
Table 1–8 Specifications and quantity of screws
Installation
Mode
Screw
Specification
Quantity (PCS)
Description
Backplate
mounting
Users purchase
the screw
according to the
mounting hole
diameter.
4
It is used to fix the drive onto the wall.
Through‑
hole
mounting
Users purchase
the screw
according to the
mounting hole
diameter.
4
It is used to fix the drive onto the
backplate of the control cabinet.
T10 to T12 models
"
Table 1–7 Tools for mechanical installation
"
on page 29
lists the tools for mechanical
installation.
"
Table 1–9 Specifications and quantity of screws
"
on page 30
lists the specifications
and quantity of screws required for mechanical installation.
Table 1–9 Specifications and quantity of screws
Installation
Mode
Screw
Specification
Quantity (PCS)
Description
Installation
within the
cabinet
M5 self‑tapping
screw
6
It is used to fix the bottom mounting
bracket to the bottom of the cabinet.
M5 x 12 SEMS
screw
8
It us used to assemble the guide rails.
M6 nut 2
It is used to connect the guide rail
assembly to the bottom mounting
bracket.
To Next Page
Loading...
