Mechanical Installation (T1 to T9 Models)
‑94‑
4.6 Cover Removal and Installation
4.6.1 Removing the Cover
Before wiring the control circuit, for example, connecting the jumper, PG card, or
functional expansion card, remove the cover of the AC drive. When removing the
cover, hold the cover with your hands and carefully lift the lower part of the cover to
prevent it from falling off. Failure to comply will result in equipment damage or
personal injury.
PPrreerreeqquuiissiitteess
Before removing the cover, ensure that the machine has been powered off for over 10
minutes.
CCoonntteexxtt
The following figure shows the positions of the control board, jumper, and expansion
card after the cover is removed.
To Next Page
Loading...
