Unpacking Inspection
‑62‑
3 Unpacking Inspection
3.1 Storage
● Store the drive in a clean and dry space, with an ambient temperature ranging
from –20℃ to +60℃ and a temperature change rate less than 1℃/min.
● For long time storage, cover the drive or take other appropriate measures to keep
it from contamination and environmental influences.
● For storage, pack the drive with the original packing box provided by Inovance.
● Do not expose the drive to moisture, high temperature, or outdoor direct sunlight
for an extended period.
● To avoid degradation of electrolytic capacitor during long‑term storage, energize
the drive once every six months, each time lasting at least 5 hours. Use a regulator
to increase the input voltage gradually to the rated value. For any doubt, contact
Inovance.
3.2 Transportation Before Unpacking
T1 to T12 models
Precautions for transportation of T1 to T12 models:
● T1 to T6 models are small and light and therefore can be handled manually. T7 to
T12 models, however, must be transported with an appropriate lifting tool.
● Fix the drive to a wooden pallet when handling with a forklift. When handing with
a crane, fix the drive to the pallet, as shown below.
To Next Page
Loading...
