Electrical Installation
‑178‑
No.
Wiring Description
3
Connect the PE cable on the output side of the AC drive to the motor
output cable shield.
4
Input protection (fuse, connect the lower end of the fuse to the filter)
5
Input power supply
6
Three‑phase motor
7
Ground the motor enclosure.
Note
Arrangement of the main circuit terminals varies with models.
8.5.3 Grounding Multiple Drives
When multiple drives are installed in the cabinet in parallel, the grounding wiring of
the drives is shown below.
Figure 8‑62 Grounding in parallel connection
To Next Page
Loading...
