MD‑SI‑DP1 Communication
‑211‑
Click Device view, and select a proper PPO type under Hardware catalog. The
addresses assigned for each segment are displayed as follows. The PKW address is
marked with a red circle in the following figure. If the selected PPO has no PKW, the
column is blank.
4. Set PZD mapping.
Click Network view and then click Device-specific parameters to set the
mapping for PZD3 to PZD12. Note that the PZD mappings for the PLC to read and
write to the slave are set independently. For details, see " "
on page
"
8.7.2
Configuring a Slave on the S7‑300 Master in STEP 7 V5.4
"
on page 198
" "
on page
.
To Next Page
Loading...
