PROFINET Communication
‑75‑
Figure 5‑2 Connecting ground terminals of the MD500‑PN1 card and AC drive
5.3 Interface Layout and Description
The following figure shows the interface and indicator layout of the MD500‑PN1 card.
The pin header J1 on the back of the MD500‑PN1 card is used to connect the AC drive.
The MD500‑PN1 card provides two network ports (J2 and J3) for communication with
the PROFINET card (PLC).
Figure 5‑3 Interface layout of the MD500‑PN1 card
Table 5–1 Interfaces and indicators of the MD500‑PN1 card
Symbol
Hardware Name Function
J1
Pin header
Check whether FD‑00 is set to 9 and FD‑
01 is set to 3.
J2
Network ports
Standard Ethernet RJ45 socket, direction‑
insensitive. J3 is used to communicate
with the PROFINET card (PLC).
J3
To Next Page
Loading...
