Inovance MD520 Series - Parameters Related to AC Drive Communication Card; Communication Control Parameters

EtherNet/IP Communication
‑237‑
Note
● The expansion card implements active conflict detection upon power‑on and
DHCP IP address assignment, and it implements passive detection at other times.
If the same dynamic (static) IP address is separately assigned to two devices,
which are then connected to a network, neither of the two expansion cards will
report an IP address conflict.
● IP address assignment by using the DHCP function will fail if an assignment
conflict occurs during the process.
9.6.3 Parameters Related to AC Drive Communication Card
Parameter No. Parameter Name Unit
Description
FD‑61
First two bytes of the
expansion card MAC
address
1
MAC address of the
expansion card
FD‑62
Middle two bytes of
the expansion card
MAC address
1
MAC address of the
expansion card
FD‑63
Last two bytes of the
expansion card MAC
address
1
MAC address of the
expansion card
FD‑58
Expansion card error
code
1
Error code of the
expansion card
9.6.4 Communication Control Parameters
Parameter No. Parameter
Name
Value Range Decimal Address
U3‑16 Frequency
reference
–Maximum frequency to
+Maximum frequency
0.01 Hz
29456
U3‑17
Control
command
0000: Stop
according to the
stop mode
defined by F6‑10
0001: Run in
forward
direction
0002: Run in
reverse
direction
0003: Jog in
forward
direction
0004: Jog in
reverse
direction
0005: Coast to
stop
0006: Decelerate
to stop
0007: Reset
upon fault
29457