EtherNet/IP Communication
‑228‑
Figure 9‑2 Connecting ground terminals of the MD500‑EN1 card and AC drive
9.3 Interface Layout and Description
"
Table 9–1
"
on page 229
shows the hardware layout of the MD500‑EN1 card. The pin
header J7 on the back of the MD500‑EN1 card is used to connect the AC drive. The
MD500‑EN1 card provides two network ports (J4 and J6) for communication with the
EtherNet/IP master (or other slaves). For details about the hardware, see "
Table 9–1
"
on page 229
.
Figure 9‑3 Interface layout of the MD500‑EN1 card
To Next Page
Loading...
