EtherNet/IP Communication
‑244‑
Select the EDS file in your computer and click Next.
Then keep clicking Next until the Finish button appears, click Finish.
Step 3: Set the IP address for the expansion card. Take a static IP address as an
example.
Set the AC drive parameters FD‑37 to FD‑49 to disable the DHCP function, set the IP
address to 192.168.0.6, set the subnet mask to 255.255.255.0, and set the gateway
address to 192.168.0.1.
Step 4: Configure the Studio 5000 project.
Click Ethernet on the left and choose New Module.
To Next Page
Loading...
