12
NS-32E740A12 Insignia 32" LED-LCD HDTV, 720p
www.insigniaproducts.com
Using composite video (good)
To connect a cable or satellite box using
composite video:
1 Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable box.
3 Connect an A/V cable (not included) to the
Y-VIDEO and L/R (audio in) jacks on the side of
your TV and to the composite video and audio
out jacks on the cable or satellite box.
4 Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the setup wizard on page 21.
Using coaxial (good)
To connect a cable or satellite box using coaxial:
1 Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable or satellite
box.
3 Connect a coaxial cable (not included) to the
ANT/CABLE jack on the back of your TV and to
the coaxial out jack on the cable or satellite box.
4 Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the setup wizard on page 21.
USB
Side of TV
Cable or satellite box
A/V cable
Cables are often color-coded
to match color-coded jacks.
Note: The yellow connector
on the AV cable plugs into the
green Y-VIDEO jack.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
Cable or satellite box
Back of TV
Coaxial cable
To Next Page
Loading...
Need help?
General
Weight and Dimensions
