SE7500CW2 Server Board Technical Product Specification Error Reporting and Handling
79
Revision 1.40
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
IO device IRQ conflict
I/O device IRQ conflict error.
PS/2 Mouse Boot Summary Screen
PS/2 Mouse installed.
nnnnM Extended RAM Passed
Where nnnn is the amount of RAM in megabytes successfully tested.
nnnnK Cache SRAM Passed
Where nnnn is the amount of system cache in kilobytes successfully tested.
nnnnK Shadow RAM Passed
Where nnnn is the amount of shadow RAM in kilobytes successfully tested.
nnnnK System RAM Passed
Where nnnn is the amount of system RAM in kilobytes successfully tested.
One or more I2O Block Storage Devices were excluded from the Setup Boot Menu
There was not enough room in the IPL table to display all installed I2O block-storage
devices.
Operating system not found
Operating system cannot be located on either drive A: or drive C:. Enter Setup and see
if fixed disk and drive A: are properly identified.
Parity Check 1 nnnn
Parity error found in the system bus. BIOS attempts to locate the a
on the screen. If it cannot locate the address, it displays ????. Parity is a method for
checking errors in binary data. A parity error indicates that some data has been
corrupted.
Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts to locate the address and display it on
the screen. If it cannot locate the address, it displays ????.
Press <F1> to resume, <F2> to Setup
Displayed after any recoverable error message. Press <F1> to start the boot process
or <F2> to enter Setup and change the settings.
Press <F2> to enter SETUP
Optional message displayed during POST.
Mouse initialized
Mouse identified
Run the I2O Configuration Utility
One or more unclaimed block storage devices have the Configuration Request bit set
in the LCT. Run an I2O Configuration Utility (e.g. the SAC utility).
System BIOS shadowed
System BIOS copied to shadow RAM.
Video BIOS shadowed
Video BIOS successfully copied to shadow RAM.
To Next Page
Loading...
