Need help?Do you have a question about the Intellian i6P and is the answer not in the manual?
Provides guidelines for selecting an optimal installation site, considering obstacles, radar interference, and vessel movement.
Details the cable connections for a single satellite receiver setup.
Provides step-by-step instructions for connecting an external GPS to the ACU.
Describes how to connect and configure the ACU via Ethernet using TCP/IP.
Describes the ACU screen sequence during system startup and initialization.
Provides instructions to enter the ACU's Setup Mode.
Provides instructions for setting up remote control functions on the ACU.
Explains how to manually control the antenna's position using the ACU.
Describes how to perform and interpret antenna diagnostic self-tests.
Explains how to restore the antenna to its factory default settings.
Introduces Aptus, the PC controller software for antenna setup and remote control.
Provides instructions for installing the Aptus software on a PC.
Details the process of establishing data communication between PC and ACU.
Details connecting and configuring the ACU via a serial port.
Guides connecting and configuring the ACU via Ethernet or Wi-Fi.
Displays the current operational status mode of the antenna.
Allows display and setting of current tracking satellites and their information.
Visualizes signal levels relative to thresholds, indicating tracking status.
Indicates system errors when the report button turns red.
Initiates full or single diagnostic tests, showing results via indicators.
Configures network settings including IP, Subnet Mask, Gateway, and DNS.
To Next Page
General
