CS3000, Users
Rev A, January, 2011
Page 4 of 35
Introduction
This manual contains specifications, operation instructions, and calibration instructions
for Intercomp's model CS3000 crane scale.
Specifications
Controls
General: Tare, lb/kg, Zero, Mode, Accum/Total, On/Off
Display: 5 1/2 digit, 1 inch liquid crystal display (LCD), with automatic
back lighting.
Electrical
Batteries: 8 X D-size alkaline
Battery life: 3000 hours (4 months continuous use)
9000 hours in Stand-by mode.
Filtering: Adjustable averaging up to 30 seconds.
Stand-by
Mode:
Scale goes into stand-by when shut off via RFX remote,
or after adjustable time without use or motion. When in
‘stand-by’ mode, scale can be turned on with the RFX
remote.
Auto-Zero: Satisfies all HB-44 requirements.
Performance
Speed 4 display updates per second
Accuracy
± 0.1% of reading or ± 1 display graduation, whichever is
greater.
Calibration
interval
Twelve months recommended
Environmental
Humidity 10 to 95% Non-Condensing.
Temperature Operating: -28 C to +65 C. / -20 F to +150 F.
Storage: -40 C to +75 C. / -40 F to +170 F.
EMI/RFI Meets Mil Spec 461
Radio
Radio frequency ISM 2.4GHz, 802.15.4
License
requirements
None. Pre-approved US/FCC, CAN/IC, EUR/CE
Range 200’ / 60m indoor, 300’ / 90m line of sight
WARNING: This equipment has been approved for mobile applications
where the equipment should be used at distances greater than 20cm from
the human body (with the exception of hands, wrists, feet, and ankles.
Operation at distances less than 20cm is strictly prohibited.
!
To Next Page
Loading...
